Cameron 164

The 164 series micro drill press has been discontinued and is no longer available as of January 1st, 2016. We will continue to service our current 164 customers with a complete line of repair and replacement parts including but not limited to motors, belts, brushes, etc. The 164 series has been replaced by the Model 214 line of micro drill presses. If you are interested in purchasing a micro drill press please check out our model 214.

Standard Features

  •  Single Speed Motor
  • Three Step Pulley System for Spindle Speeds:
    • 9,500rpm, 17,000rpm, 30,000rpm
  • Smooth Rack and Pinion Feed
  • Drills Small Holes (0.002″ TO 5/32″)
  • Can Drill to the Center of a 5″ Work Piece
  • Spindle Run Out at the Chuck Mounting Taper is within 0.0002″
  • Dynamically Balanced Spindles, Pulleys and Motors for smoothness in operation
  • Clear Plastic Safety Guard for viewing belt & pulley position
  • Slotted 4″ x 4″ work table with 5/8″ center hole
  • J0 Taper (J1 Taper if 0-1/4″ chuck is installed)*

* – 0-1/4″ chuck no longer available on current models

Options

  • 164-A-1 – Yukiwa 0-5/32″ Key Type Chuck with key
  • 164-A – Jacobs 0-5/32″ Key Type Chuck with key
  • 164-C1 – Albrecht 0-1/8″ Keyless Chuck (Thru-Hole Chuck available)
  • 164-C2 – Albrecht 0-1/16″ Keyless Chuck (Thru-Hole Chuck available)
  • 164-C3 – Yukiwa 0-1/8″ Keyless Chuck
  • MD162-7 – Precision Ground Reservoir Base
  • MD156-H – Hollow Spindle w/ Pulley for Special Applications (requires a thru-hole chuck)
  • MD161-7 – Table Column Stop
  • MD151-7 – Travel Dial Indicator (metric indicator available – MD151-7MM)
  • MD159-2A – Variable Speed Controller (120/240 V. A/C)
  • MD159-FS – VSC Foot Switch